Skylink WALL MOUNT TB-318 - Manual (Page 2)

8. FCC
10. CUSTOMER SERVICE
The Remote Control is approved by the FCC and it complies with Part 15 of the
FCC Rules. Its operation is subject to the following two conditions :
1. This device may not cause harmful interference.
2. This device must accept any interference that may cause undesired operation.
WARNING:
Changes or modifications to this unit not expressly approved by the party responsible
of compliance could void the user’s authority to operate the equipment.
CUSTOMER SERVICE
17 Sheard Avenue, Brampton, Ontario, Canada L6Y 1J3
Email:[email protected]
http://www.skylinkhome.com
P/N. 101A396
Patent Pending
©2010 SKYLINK GROUP
11. ACCESSORIES
7. BATTERY
When the operating range is reduced, or when the red LED does not
flash during operation, it is time to replace the battery. Follow the same
procedure as installing the battery in section 2 of this manual to replace
the battery.
Note: Dispose of old batteries promptly and properly.
6. ERASING WALL MOUNT TRANSMITTER FROM RECEIVERS
You may erase a transmitter from the receiver module, but you cannot
erase a specific device directly, you must erase all the wireless devices,
then program the ones you want to keep. Follow the instructions below
to erase programmed transmitters.
1. Power off the receiver module.
2. Press the SET button on the transmitter.
3. Press and hold the programmed pad on the transmitter for at least 2
seconds. Do not release it until step 5.
4. Power up the receiver module, you will hear a beep.
5. You may release the pad on the transmitter.
6. When the pad is release, the receiver will beep, indicating you have
successfully erased all the devices from the lighting receiver.
Erasing Wall Mount transmitter from the ON/OFF/Dimming Control
model MD-318 or ON / OFF Control model MR-318
If you would like to erase a wall mount transmitter from other receiver
modules, such as WR-001, WE-001, PA-318, PR-318, PL-318, LS-318,
etc., Please also refer to the user's instructions of that receiver module.
Note: The difference between programming a TC remote and
programming a TB remote is as following:
1. Press the PROG button on the back of a TC remote will activate
programming.
2. Press the SET button on a TB transmitter will activate programming.
Erasing wall mount transmitter from other receivers
V1.9
TM The SkylinkHome System consists of many other devices such as
TM SkylinkHome Remotes, Motion Sensor, ON/OFF Wall Switch, Wall
Dimmer, Plug-In Dimmer with or without Repeater, Plug-In ON/OFF
Control (Outdoor/Indoor), Screw-In Dimmer, ON/OFF/Dimming Control,
TM ON/OFF Control, Smart Button Garage Door Control, etc. Please visit
Skylink website at www.skylinkhome.com for more information.
9. WARRANTY
If, within one year from date of purchase, this product should become defective
(except battery), due to faulty workmanship or materials, it will be repaired or
replaced, without charge. Proof of purchase and a Return Authorization are required.
If you would like to
- find out the up-to-date specifications
- know more about features and applications
- download documents, i.e. user’s instructions
- order Skylink products
or if you have difficulty getting products to work, please:
1. visit our FAQ section at www.skylinkhome.com, or
2. email us at [email protected], or
3. call our toll free at 1-800-304-1187 from Monday to Friday, 9 am to 5 pm EST.
Fax (800) 286-1320