Samsung SW-252 - Manual (Page 7)

13
What is Buffer Under-Run?
Every CD-R or CD-RW drive records the data that the Host PC wants to record
until the data flow ends.
However, if the buffer becomes empty temporarily, this may cause errors in
recording data.
What is Auto-Run?
If inserting a CD into a drive, the operating system executes the Autorun.inf file
of the CD automatically.
What is Exaclink?
This function is to check the buffer to see if there are data while recording.
If the buffer is empty, it waits at the address and then restarts recording after
the buffer is full.
You can avoid Buffer Under-Run problems by applying the above-mentioned
principle.
Solving Technical Problems
14
Recommended Disc Types
CD-R MCC, RITEK, CMC, SKC, BEALL, PRODISK, MAXELL, ACER, MPO,
FUJI, TAIYO YUDEN, TDK, GIGA, PLASMON
CD-RW CD-RW(1X-4X) : RICOH, RITEK, MCC, ACER, SKC, CMC
H/S-RW(10X) : RICOH, CMC, RITEK, ACER, SKC, MCC
U/S-RW(24X : MCC, RITEK
Term Description
Problem
The CD-R/RW drive is not
detected by the computer.
After installing the CD-R/RW
drive, the PC gets slower.
Check that the power, audio and IDE cables are
correctly connected to the computer.
Change the IDE cable and reconnect it to the
computer.
Preferably, connect a second IDE cable to the
CD-R/RW drive in master mode.
Meaning / Solution
The CD-R/RW drive is not
recognized by MS-DOS. Reinstall the device driver or update it with the
latest version by downloading it from the
Samsung Web site.
- www.samsung-ODD.com
- www.samsungelectronics.com
The CD-R/RW drive is not
detected by Windows. This case may occur when there is a Windows
installation problem; reinstall Windows.
No sound is heard from an
audio CD. Check whether the audio cable is correctly
connected to the sound output terminal on the
CD-R/RW drive and the sound card CD-IN terminal.
A CD is not read or is read
too slowly. Check whether the CD is of good quality and clean it,
if necessary.
The disc compartment will
not open. Check that the power cable is correctly connected.
Power off and disconnect the PC.
Insert a pin or unfolded paper clip in the emergency
hole and push firmly until the disc compartment opens.
Check that the sound card is operational.
Adjust the volume control.
Run the CD player supplied with Windows or your
sound card.
You can listen to the CD by connecting headphones
to the appropriate connector.
If you have installed the appropriate player, such as
Microsoft Windows Media Player, you can adjust the
volume using the headphone volume control on the
drive front panel.
If you select DIGITAL at CD Audio Play in Media
Player of Windows ME/XP, the earphone does not
appear in the Digital Mode.
Check the position of the jumper in the master/slave
select terminal.