Samsung SU-8500 - Manual (Page 12)

Maintenance
*Brushbar Replacement
*Belt replacement
1 Remove the tool from the hose, and turn upside down. Slide the switch to unlock position
and remove bottom plate.
2 Unscrew the one screw and remove belt guard.
3 Remove brushbar including end plates and discard.
4 Inspect belt to ensure that it is in good condition. If broken or cracked, please replace.
(See below for details.)
5 With the curved ends facing down, slide end plates of brushbar into slots on the tool.
6 To replace bottom plate, insert the four tabs on edge of bottom plate into slots on front of
tool. Pivot bottom plate down and snap closed.
1 Grasp turbine and pull firmly to remove.
2 Remove a screw, and lift the cover belt off.
3 Remove belt from turbine pulley. Replace with new belt.
4 With flat sides of turbine retainers pointing down, slide retainers into grooves in tool
housing and snap into place.
5 Replace brushbar and bottom plate.
*Cleaning Brushbar
• Cut off pet hairs or threads surrounding brush by using scissors.
12 12
Powered hand tool(Turbine Brush)