Smeg FR132A1 - Manual (Page 8)

19
AFTER-SALES SERVICE
Before contacting After-Sales Service:
1. See if you can solve the problem yourself with the
help of the “Troubleshooting guide”.
2. Switch the appliance on again to see if the problem
has been solved. If it has not, disconnect the
appliance from the power supply and wait for
about an hour before switching on again.
3. If the problem persists after this course of action,
contact After-sales Service.
Specify:
• the nature of the problem,
• the model,
• the Service number (the number after
SERVICE on the rating plate located on the
side of the fruit and vegetable drawer)
• your full address,
• your telephone number and area code.
Note:
The direction of door opening can be changed.
If this operation is performed by After-sales
Service it is not covered by the warranty.
INSTALLATION
• Install the appliance away from heat sources (minimum
distances: 30 cm from coal and paraffin stoves, 3 cm from
electric ovens and hobs).
• Install the appliance in a dry, well-ventilated place.
• Do not obstruct the air vents.
• Clean the appliance interior (see relevant chapters).
• Fit the accessories supplied.
Electrical connection
• Electrical connections must be made in accordance
with local regulations.
• Voltage and power consumption are indicated on the rating
plate (at the side of the crispers)
• Regulations require that the appliance is earthed.
The Manufacturer declines all liabilities for injury to
persons or animals or damage to property resulting
from failure to observe these regulations.
• If the plug and socket are not of the same type, have the
socket replaced by a qualified electrician.
• Do not use extension leads or adapters
Disconnecting the appliance
• It must be possible to disconnect the appliance by
unplugging it or by means of a two-pole switch fitted upline
of the socket.
60833048GB.fm Page 19 Thursday, March 24, 2005 9:10 AM