Sears C944.414460 User Manual

Page 21

Advertising
background image

21

TROUBLESHOOTING TABLE -- Continued

TROUBLE

CAUSE

REMEDY

Chain moves at
idle speed.

1. Idle speed requires

adjustment.

2. Clutch requires repair.

1. See “Carburetor Adjustment” in the

Service and Adjustments Section.

2. Contact Sears Service (see back cover).

1. Chain tension too

tight.

2. Carburetor requires

adjustment.

3. Guide bar rails

pinched.

4. Clutch slipping.
5. Chain brake engaged.

Chain does not
move when en-
gine is acceler-
ated.

1. See “Check Chain Tension” in the

Maintenance Section.

2. Contact Sears Service (see back cover).

3. Repair or replace.

4. Contact Sears Service (see back cover).
5. Disengage chain brake.

Chain clatters
or cuts roughly.

1. Chain tension incorrect.

2. Cutters damaged.
3. Chain worn.
4. Cutters dull, improperly

sharpened, or depth
gauges too high.

5. Sprocket worn.
6. Chain installed

backwards.

1. See “Check Chain Tension” in the

Maintenance Section.

2. Contact Sears Service (see back cover).
3. Resharpen or replace chain.
4. See “Chain Sharpening” in the

Service and Adjustments Section.

5. Contact Sears Service (see back cover).
6. Install chain in right direction.

Chain stops
within the cut.

1. Chain cutter tops not

filed flat.

2. Guide bar burred or

bent; rails uneven.

3. Clutch slipping.

1. See “Chain Sharpening” in the

Service and Adjustments Section.

2. Repair or replace guide bar.

3. Contact Sears Service (see back cover).

Chain cuts at
an angle.

1. Cutters damaged on

one side.

2. Chain dull on one side.

3. Guide bar bent or worn.

1. See “Chain Sharpening” in the

Service and Adjustments Section.

2. See “Chain Sharpening” in the

Service and Adjustments Section.

3. Replace guide bar.

If situations occur which are not covered in this manual, use care and good
judgement. If you need assistance, contact your Sears Service Centre.

Oil inadequate
for bar and
chain
lubrication.

1. Oil tank empty.
2. Oil pump or oil filter

clogged.

3. Guide bar oil hole

blocked.

1. Fill oil tank.
2. Contact Sears Service (see back cover).

3. Remove bar and clean.

Advertising