Sony CMD-J26 - Manual (Page 9)

9
• The Centre Key
# Press the Centre Key in standby mode to access the WAP mode if WAP settings are configured.
(CMD-J6 only)
# During a call, press the Centre Key to access the Call Menu.
# In Sub-menus, access/exit the help function by pressing the Centre Key
• The Voicemail Key
# Press and hold to access your Voicemail
• The Side Switch
# In standby mode, slide the switch up to activate/deactivate the manner modes.
# Afterwards, it is possible to switch among the manner mode functions. All manner mode icons appear
in the display; rotate the Jog Dial to select one:
# For your convenience, sliding the side switch up in standby mode will toggle between the two last
settings.
# In standby mode, slide the switch down to lock/unlock your keypad (including Jog Dial). It is still
possible to make emergency calls (112) as well as answer/reject an incoming call (by pressing /
) when the keypad is locked.
# During a call, turn the loudspeaker on by sliding the switch up once. Turn the loudspeaker off by
sliding the switch up again.
# During an incoming call, stop the ringer by sliding the side switch up.
# During a game, stop/start the backround sound by sliding the side switch up.
3.2 Security Codes
CODE TYPE
NUMBER OF
DIGITS
DESCRIPTION
PIN
Personal Identification Number
4 to 8
Controls SIM security. Supplied by the
Service Provider !
PIN 2 4 to 8
Controls memory security. Supplied by the
Service Provider !
PIN / PIN 2
Personal Unblocking Key
(PUK / PUK 2)
8
Used to unblock PIN and PIN 2.
A PIN or PIN 2 will become blocked if the wrong
PIN or PIN 2 is entered three times.
When the blocked PIN or PIN 2 is unblocked, a
new PIN or PIN 2 must be entered. If the wrong
PUK or PUK 2 is entered 10 times, the SIM card
will be unusable.
Supplied by the Service Provider !
Bearing Password 4
Controls the call bar function. If the wrong
password is entered three times, this
service will be revoked.
Supplied by the Service Provider !
Security Code 4 to 8
Controls the access to wap-and e-mail settings.
The default Security Code is: 0000
Refer to Section 5 “Programming Instructions”
Silent Mode :turns the ringer and all tones to silent mode.
Ringer to Single beep :ringer is restricted to a discrete single beep.
Vibra Alert :Vibra Alert without the ringer.