Silvercrest SEM 1100 A1 - Manual (Page 17)

15 Espresso Machine
GB
IE
Generating hot water
When the appliance is heated-up: 1)
Place a cup under the milk frother 2) z.
When the green heating-up control lamp 3) 4 glows, turn the steam control
knob 2 to the position “+”.
Turn the rotary switch 4) 5 to the position “ ”. Hot water fl ows from the noz-
zle.
If you wish to interrupt the hot water supply, turn the steam control knob 5) 2
off (as far as it will go in the direction “-”) and place the rotary switch 5 at
the position “
”.
Switch the appliance off with the on/off switch 6) 3.
Cleaning and Care
WARNING - RISK OF INJURY!
Always remove the plug from the mains power socket before you clean the ■
appliance. Risk of electric shock!
Always allow the appliance to cool down before you start to clean it. Risk of ■
Burns!
NEVER submerse the appliance in water or other liquids. Risk of electric ■
shock!
Cleaning the milk frother
ATTENTION - PROPERTY DAMAGE
NEVER use abrasive, corrosive or chemical agents to clean the appliance. ■
These could damage the upper surfaces of the appliance.
Place an empty container under the milk frother
1) z.
Immediately after use turn the steam control knob 2) 2 to the position “+ “ and,
for a few seconds, allow the steam to escape.
Turn the steam control knob 3) 2 off (as far as it will go in the direction “-”),
switch the appliance off and remove the plug from the mains power socket.
Allow the nozzle to cool down. 4)
Remove the nozzle and clean it thoroughly in warm water. 5)
Check to see if the small hole in the nozzle is clogged and, if so, clear it with 6)
a needle.