Samsung DA99-00275B - Manual (Page 30)

INSTALLING THE WATER DISPENSER LINE
30
WATER LINE
PURIFIER
OUTLET SIDE
OF PURIFIER
WATER
Remove any residual matter inside the purifier. (Model with the purifier)
- Open the main water tap to check whether water
is running through the water tube on the water
inlet side of the purifier.
- If water does not come out through the line,
check whether the tap is open.
- Leave the tap open until clean water is running
out and any residual matter that built up during
manufacturing has been removed.
- Cut the water line attached to the purifier
to the appropriate place after measuring
the distance between the purifier and the
cold water tap.
- If you wish to reassemble the water inlet
and outlet sides of the purifier during purifi-
er installation, see the reference illustra-
tion.
Select the location where the purifier is to install. (Model with the purifier)
WATER INLET SIDE
OF PURIFIER
LINE
OUTLET
SIDE OF
PURIFIER
PURIFIER
WATER
COUPLER
REFERENCE
90 degree
Connect to the water supply line
For Exterior model
Connect the water pipe with coupler and tap.
- Close the main water tap.
- Connect coupler “A” to the tap.
- Every join should be protected with sealing tape.
Note:
If the coupler does not fit on the current tap, go
the nearest authorised service dealer and purchase
the right couplers fittings.
WARRANTY INFORMATION
This water line installation is not covered by the
refrigerator or ice maker manufacturer's warranty.
Follow these instructions carefully to minimise the risk
of expensive water damage.
TAP
COUPLER “A”
The water line must be connect-
ed to the cold water pipe.
If it is connected to the hot
water pipe, it may cause the puri-
fier to malfunction.
CAUTION