Woodstock SHOP FOX M1001 - Manual (Page 20)

-18-
M1001 6" x 26" Vertical Mill
O
PE
R
ATIO
NS
OPERATIONS
General
DO NOT investigate problems or adjust
the mill while it is running. Wait until
the machine is turned off, unplugged
and all working parts have come to a
complete stop before proceeding!
The Model M1001 will perform many types of operations
that are beyond the scope of this manual. Many of these
operations can be dangerous or deadly if performed incor-
rectly.
The instructions in this section are written with the under-
standing that the operator has the necessary knowledge
and skills to operate this machine. If at any time you
are experiencing difficulties performing any operation,
stop using the machine!
If you are an inexperienced operator, we strongly recom-
mend that you read books, trade articles, or seek training
from an experienced vertical mill operator before per-
forming any unfamiliar operations. Above all, your safety
should come first!
Always wear safety glasses when oper-
ating the mill. Failure to comply may
result in serious personal injury.
READ and understand this entire instruc-
tion manual before using this machine.
Serious personal injury may occur if
safety and operational information is not
understood and followed. DO NOT risk
your safety by not reading!
The spindle head can be rotated vertically 45˚ both ways,
and can rotate horizontally on the column 45˚ in both
directions.
To rotate the spindle head vertically, do these steps:
1. UNPLUG THE MILL!
2. Make sure the spindle is stopped and the work area
is free from obstructions before proceeding.
3. Loosen the four nuts that lock the headstock in place
with a 17mm wrench (see Figure 14 on next page).
4. Rotate the headstock to the desired angle.
5. Tighten the spindle locking nuts.
Note: Additional setup tools should be used to determine
the precise angle of the spindle head.
Positioning Spindle Head