Battery life, Troubleshooting, Switching to a line source – Saitek TM A-350 User Manual

Page 4

Advertising
background image

BATTERY LIFE

In normal use, your wireless headphones should give 6hrs playing time on one
recharge.
To save battery life or when the batteries require recharging, simply connect your
headphones to the music source using the 3.5mm jack cable provided.

TROUBLESHOOTING

My M

MP3 pplayer iis pplaying m

music, bbut II ccannot hhear aany ssound ffrom m

my hheadphones.

Check that the headphones' volume is not at 0. Press the volume up button to
increase volume until you can hear the music.
Check that the wireless transmitter's jackplug is properly inserted in your music
player's audio socket.
Check that your music player’s volume control is not at “0”. If it is, increase it.
Check that the batteries have not run out. If the LED on either the headphones or
transmitter is red or not lit up at all, recharge either or both units.
Check that there is a wireless connection between the transmitter and headphones
unit.
To improve the signal range:
Allow as much free space as possible between the transmitter and receiver, and avoid
placing dense or metal objects between them.
As the headphones antenna is on the left side of the unit, try to place the wireless
transmitter on your left side to improve the connection.
If the signal is lost the two units will take a few seconds to re-establish a connection.

SWITCHING TO A LINE

SOURCE

To switch from the wireless transmitter to 3.5mm Line-in as audio source,
connect the headphones to your audio source with the 3.5mm jackplug cable.
Press and hold 'Vol -' for 5 seconds.The LED will then light up blue for 2 seconds
then go off to show that the connection has now switched to Line-in.
Default audio source on Power On is 'Wireless Audio Streaming'.
To revert back to wireless audio streaming mode, Press and hold 'Vol -' for 5
seconds.The unit will then re-establish a wireless connection with the transmitter.
The volume will also return to the previous level after the audio source is
changed.
Please note:You can only switch to a Line-in source if there is still power left in
the battery. If there is insufficient power, recharge the headphones.

dmeQSGA350.qxd 11/2/2005 12:40 PM Page 6

Advertising