Sony DPP-FPHD1 - Manual (Page 21)

21
Troubleshooting
If you run into any problems using the printer, use the following guidance to solve the
problem. If the problem persists, consult your Sony dealer.
x Power/Charging
Cannot turn on the printer.
• Check whether the AC power cord is properly connected to an AC outlet.
Unable to charge the battery pack (when the CHARGE indicator fails to light).
• Turn the camera off.
• Check whether the AC adaptor is properly connected.
• Check whether the camera is placed properly on the camera adaptor.
• Check whether the battery pack is installed correctly.
• The battery pack is completely charged.
• The battery pack installed into the camera is inapplicable. Install the battery pack compatible
with your camera.
• The motor in the printer is still running. Turn off the camera after the motor stops running.
The CHARGE indicator flashes fast, or flashes for more than 10 seconds.
• The battery pack installed into the camera is inapplicable. Install the battery pack compatible
with your camera.
• Check whether the camera is placed properly on the camera adaptor.
Unable to turn on the camera, or the power suddenly turns off.
• Check whether the camera is placed properly on the camera adaptor.
• Check whether the AC adaptor is properly connected.
x Connecting with a camera
The ACCESS indicator of the printer does not light.
• Check whether the cable is properly connected.
• Check whether the power of the printer is turned on.
• When the ACCESS indicator of the printer flashes, follow either step below.
– Disconnect the camera and the printer and then connect them again. Or turn off and then
turn on the printer and the camera.
– The camera is set to “Mass Storage”. Change the settings to “PictBridge” or “Auto”.
If trouble occurs