Sony DPP-FPHD1 - Manual (Page 27)

27
Precautions
• Be careful not to set or drop any heavy
objects on the power cord, or to damage
the power cord in any way. Never operate
this printer with a damaged power cord.
• Should any solid object or liquid fall into
the cabinet, unplug the printer and have it
checked by qualified personnel before
operating it any further.
• Never disassemble the printer.
• To disconnect the power cord, pull it out
by the plug. Never pull the power cord
itself.
• When the printer is not going to be used
for an extended period of time, disconnect
the power cord from the wall outlet.
• Do not handle the printer roughly.
• To reduce the risk of electrical shock,
always unplug the printer from the
electrical outlet before cleaning and
servicing the printer.
• Be sure to install the printer horizontally
or vertically in the instructed way.
Otherwise, this may cause a malfunction.
• Avoid placing the printer in a location
subject to:
– vibration
– high humidity
– excessive dust
– direct sunlight
– extremely high or low temperatures
• Do not use electrical equipment near the
printer. The printer will not work properly
in electromagnetic fields.
• Do not place heavy objects on the printer.
• Leave enough room around the printer so
that the ventilation holes are not blocked.
Blocking these holes may cause internal
heat build-up.
On the AC adaptor
• Be sure to use the AC adaptor supplied
with the printer. Do not use other AC
adaptors, as this may cause a malfunction.
• Do not use the supplied AC adaptor to
other devices.
• Do not use an electrical transformer
(travel converter), as this may cause
overheat or a malfunction.
• In case the cord of the AC adaptor is
damaged, never use it any longer, as this
may cause danger.
On moisture condensation
If the printer is brought directly from a cold
location to a warm location or placed in an
extremely warm or humid room, moisture
may condense inside the unit. In such cases
the printer will probably not work properly
and may even develop a fault if you persist
in using it. If moisture condensation occurs,
unplug the AC power cord of the printer
and do not use the printer for at least one
hour.
On transport
When you transport the printer, remove the
ink ribbon, paper tray or AC adaptor, from
the printer and put the printer and its
peripherals in the original box with the
protective packaging.
If you no longer have the original box and
packing parts, use similar packing material
so that the printer will not be damaged
while being transported.
Clean the cabinet, panel and controls with a
soft dry cloth, or a soft cloth lightly
moistened with a mild detergent solution.
Do not use any type of solvent, such as
alcohol or benzine, which may damage the
finish.
On safety
On installation
On cleaning