Sony DSX-S310BTX - Manual (Page 37)

37
Music streaming
Listening to music from an audio
device
You can listen to music of an audio device on this
unit if the audio device supports A2DP
(Advanced Audio Distribution Profile) of
Bluetooth technology.
1
Connect this unit and the Bluetooth
audio device (page 33).
“
” appears during connection.
2
Turn down the volume on this unit.
3
Press (SOURCE/OFF) repeatedly until
“Bluetooth Audio” appears.
4
Operate the audio device to start
playback.
5
Adjust the volume on this unit.
Adjusting the volume level
The volume level is adjustable for any difference
between the unit and the Bluetooth audio device.
1 Start playback of the Bluetooth audio device at
a moderate volume.
2 Set your usual listening volume on the unit.
3 Press the multi-way encoder.
4 Rotate the multi-way encoder until “Bluetooth
Audio Level” appears, then press it.
5 Rotate the multi-way encoder to adjust the
input level (“+ 18dB” – “0dB” – “– 8dB”).
Operating an audio device with this
unit
You can perform the following operations on this
unit if the audio device supports AVRCP (Audio
Video Remote Control Profile) of Bluetooth
technology. (The operation differs depending on
the audio device.)
*1 Depending on the device, it may be necessary to
press twice.
*2 Press repeatedly until the desired setting appears.
*3 You can also shuffle play by pressing and holding
(ZAP/SHUF) on this unit.
Operations other than the above should be
performed on the audio device.
Notes
• Depending on the audio device, its information, such
as title, track number/time, playback status, etc.,
may not be displayed on this unit. The information is
displayed during Bluetooth Audio playback only.
• Even if the source is changed on this unit, playback
of the audio device does not stop.
Tip
You can connect a cellular phone that supports A2DP
(Advanced Audio Distribution Profile) as an audio
device and listen to music.
Other settings
Initializing Bluetooth Settings
You can initialize all the Bluetooth-related
settings from this unit.
1
Press and hold the multi-way encoder.
The menu list appears.
2
Rotate the multi-way encoder to select
“BT Initialize,” then press it.
The confirmation appears.
3
Rotate the multi-way encoder to select
“Yes.”
“Initializing...” appears while initializing the
Bluetooth settings.
4
Press (BACK).
The display returns to normal reception/play
mode.
Note
When disposing of this unit, phonebook data should
be deleted with “BT Initialize.”
To Do this
Play Press (PAUSE).* 1
Pause Press (PAUSE).* 1
Skip tracks Push the multi-way encoder
left/right [once for each track].
Reverse/
Fastforward Push and hold the multi-way
encoder left/right.
Repeat play Press (REP) on the card
remote commander.*
2
Shuffle play Press (SHUF) on the card
remote commander.*
2 * 3
Skip albums Push the multi-way encoder up/
down.