Smeg FC66B - Manual (Page 9)

41
Instructions for the user
7.3 First use
At first use, or after a power failure, the oven's display (DSP1) will show a
flashing symbol. To be able to start any cooking function the current
time must be set.
(For further information on setting or changing the current time see “7.6
Secondary menu”).
7.4 Function selection
To select a cooking function, turn PT2.
Then use the PT1 knob to select the desired temperature
7.4.1 Cooking with preset temperature
Once the desired function has been selected, the oven will begin cooking
at the pre-set time. Cooking is preceded by a pre-heating phase
(common to all functions) which allows the oven to reach the cooking
temperature more quickly.
This phase is indicated by the symbol flashing on the display (DSP1).
At the end of the pre-heating phase, the symbol will remain constantly
on to indicate that the food can be placed inside the oven.
7.4.2 Changing the preset temperature
The temperature preset for each function can be changed to suit the user's
requirements.
At any time while cooking is in progress, turn PT1 in either direction to
increase or decrease the cooking temperature by 5 degrees at a time. PT1
can also be held in the left or right position to increase or decrease the
setting more quickly.
7.5 Programmed cooking procedures
7.5.1 Cooking timed with the timer
From ON status (see point “7.2 Operating modes”), press PT1 once. The
display will show the
figures (constantly on) and the symbol
(flashing). Turn PT1 to set the minutes of cooking (from 00:01 to
23:59:00). After a few seconds, the
symbol will stop flashing and stay
on constantly; the countdown will start from that moment. At this point it is
also possible to select the cooking function required and wait for the
buzzer to sound, indicating that the cooking time is over.
Press PT1 once to stop the buzzer. You can now set an additional cooking
time by turning PT1, or return to display of the current time by pressing
PT1 twice.
Turn PT2 to the “0” symbol to switch off the oven.
The minute minder also works with no function set.