Servis-Rhino CY72 - Manual (Page 132)

MAINTENANCE
CY72 01/08 Maintenance Section 5-8
© 2008 Alamo Group Inc.
MAINTENANCE
Avoid personal injury. Always block the cutter up to prevent it from falling when the blades
and/or carrier are being serviced.
Proper Torque For Fasteners
The chart lists the correct tightening torque for fasteners. When bolts are to be tightened or replaced, refer to
this chart to determine the grade of bolts and the proper torque except when specific torque values are
assigned in manual text.
Recommended Torque in Foot Pounds Unless Otherwise Stated in the Manual*
NOTE: These values apply to fasteners as received from supplier, dry or when lubricated with normal engine
oil. They do not apply if special graphited or molydisulphide greases or other extreme pressure lubricants are
used. This applies to both UNF fine and UNC coarse threads.
Replace bent or broken blades with new blades. NEVER ATTEMPT TO STRAIGHTEN,
WELD, OR WELD HARDFACING ON BLADES SINCE THIS WILL LIKELY CRACK OR
OTHERWISE DAMAGE THE BLADE WITH SUBSEQUENT FAILURE AND POSSIBLE
SERIOUS INJURY FROM THROWN BLADES.
(SGM-10)