Driver installation – SIIG 700 User Manual
Page 3
3
Driver Installation
This section provides information on how to install the
FireWire 800 ExpressCard drivers.
Windows 2000
Windows 2000 automatically installs it's built-in 1394a
driver for the FireWire 800 ExpressCard. To get the full
speed out of this controller, install the Firewire 800 driver
using the directions below.
1.
Insert the driver CD. Click Start, Run. Type
D:\setup32.exe, click OK. (Change D: to match
your CD-ROM drive letter)
2.
At the Welcome screen, click Next.
3.
At the License Agreement screen, click Yes.
4.
At the Destination Location screen, click Next.
5.
Select Complete, then click Next.
6.
At the Program Folder screen, click Next.
7.
At the Digital Signature screen, click Yes, then click
Finish.
8.
Select the restart Windows option, then click Finish.
Windows XP (32-bit)
Windows XP automatically installs it's built-in 1394a
driver for the FireWire 800 ExpressCard. To get the full
speed out of this controller, install the Firewire 800 driver
using the directions below.
1.
Insert the driver CD. Click Start, Run. Type
D:\setup32.exe, click OK. (Change D: to match
your CD-ROM drive letter)
2.
At the Welcome screen, click Next.