Woodstock 17" Drill Press W1680 - Manual (Page 14)

Figure 16. Tighten setscrews to secure headstock.
Figure 17. Installing handles.
Figure 17b. Installing a light bulb.
Handles
Three handles are supplied with your new Drill
Press. Thread them into the hub. Figure 17.
Installing Light Bulb
The Shop Fox ® 17" Drill Press is fitted with a light
socket that accommodates standard sized bulbs.
Before installing a light bulb, unplug the drill
press. Secure bulb in opening behind the spindle
as in Figure 17b.
3. Tighten the two setscrews in Figure 16 to
secure the headstock to the column
-13-
ASSEMBLY
Unplug the drill press
before replacing the light
bulb. Failure to do this
may result in serious per-
sonal injury.
Use only bulbs that are “safety coated” and
shatter resistant. The bulb will be exposed
at the bottom of the head casting which
helps with illumination. Impacts with a bulb
not “safety coated” may shatter, exposing
the electrical filaments and creating an
electrical shock hazard.