Sunbeam EM3500S - Manual (Page 20)

18
16. After 2 minutes stop the machine by
flicking the power switch on the machine
to the ‘Off’ position. Now that the
machine is off, turn the selector dial to
the
setting.
17. Leave the machine off for 10-15 minutes
to allow the descaler to take affect.
18. Flick the power switch ‘On’ and allow
1
/
2
of the rest of the descaler solution to run
through the brewing head, then turn the
selector dial immediately to the
setting. Steam for 3-4 minutes.
19. To finish, turn the selector dial to the
setting and allow the remaining water in
the reservoir to run through the brewing
head.
20. Remove and empty the containers placed
under the brewing head and steam
nozzle. Once emptied, once again place
one under the brewing head and the
other under the steam nozzle.
21. Remove the water reservoir from the
machine and rinse thoroughly under
running water, ensuring that all traces of
the descaling solution is removed. Fill
the water reservoir with clean water and
place onto the machine.
22. Run two (2) full water reservoirs through
the brewing head. Refill the water
reservoir and run the steam nozzle for
4-5 minutes.
Note: Ensure that you continue to run
water through the machine until the
water runs clean and clear.
23. When this is finished, remove the water
reservoir and set aside. Remove the water
containers and give the machine a good
wipe over.
24. Turn the machine upside down. The
machine should now be on the warming
plate resting on the cloth/tea towel once
again.
25. Carefully replace the brew head rubber
seal, filter and screw. Tighten well.
26. Turn the machine upright, so that it is
now sitting correctly on the bench.
27. Replace the drip tray and froth enhancing
steam attachment onto the steam nozzle.
28. Fill the water reservoir with water and
position it on to the machine.
Descaling (continued)