Smeg S45MCX - Manual (Page 14)

GB-IE
Instructions for the User
15
The defrosting time will be calculated based on the food’s type and weight
and the microwaves power will be automatically varied to achieve the best
thawing results.
The following table shows the defrosting by weight function programmes,
indicating weight intervals, and defrosting and standing times (in order to
ensure the food is of a uniform temperature).
PROGRAMME FOOD WEIGHT (G) TIME (MIN)
STANDING
TIME (MIN)
PR 01 MEAT 100 – 2000 2 – 43 20 – 30
PR 02 POULTRY 100 – 2500 2 – 58 20 – 30
PR 03 FISH 100 – 2000 2 – 40 20 – 30
PR 04 FRUIT 100 – 500 2 – 13 10 – 20
PR 05 BREAD 100 – 800 2 – 19 10 – 20
7.4.10 Pizza function
After selecting this function, the weight light starts to blink.
Turn PT1 to the right or left to change the preset Pizza weight.
Press PT2 to start the cooking process.
7.4.11 Delayed Start Time (Automatic cooking)
When PT1 is pressed to define a delayed start time the corresponding
light
starts to blink, DSP1 shows the current time and DSP 2 shows
“Auto”.
Turn PT1 to the right or left to change the delayed start time.
Press PT2 to validate the delayed start time.
The oven enters in an idle state waiting for the defined start time. DSP3
shows the selected function and DSP1 and DSP2 show all the defined
parameters for the function continuously alternating.
If you wish to start the function before the selected time, just press PT2.
If you wish to cancel the programming, press PT2 for 3 seconds.
7.5 When the oven is working…
7.5.1 Interrupting a cooking cycle
You can stop the cooking process at any time by pressing the Start/Stop
key once or by opening the oven door. In both cases:
Microwave emission is stopped immediately.
The grill is de-activated but is still very hot. Danger of burning!
The timer stops and the display shows the remaining amount of
operating time.
If you wish, at this time you can:
Turn or stir the food to ensure it will be evenly cooked.
Modify the process parameters.
Cancel the process by pressing PT2 for 3 seconds.
To restart the process, close the door and press PT2.
7.5.2 Modifying parameters
The operating parameters (time, weight, power, etc.) can only be modified
when the cooking process has been interrupted. Proceed as follows:
Turn PT2 to the right or left to change the function.