Sprint Nextel S720 - Manual (Page 26)

20 Section 2A: Installing the Sprint Mobile Broadband Card
Once the card is provisioned successfully, it will start IOTA
(Internet Over-the-Air) Activation to update your user profile
from the Sprint PCS network settings. If the card is not
provisioned or out of the Sprint coverage area, the Sprint PCS
Vision User Interface will display “Sprint PCS Vision:
Searching for service...”.
Inserting and Removing the Sprint Mobile
Broadband Card
Inserting the Sprint Mobile Broadband Card
Before you insert the Sprint Mobile Broadband Card, you
must first install the Sprint PCS Connection Manager
Software (see page 16 in this section). Once you have
completed the software installation procedure, you may
insert your card into your computer’s PC Card slot. The Sprint
label should be facing up and the 68-pin connector, located at
the end of the card, should be inserted directly into the
computer’s PC Card slot.
A portion (the black section) of the card will remain outside
the PC Card slot. This section contains the card’s antenna and
the LED (light emitting diode). Because the card is not entirely
contained in your computer’s PC Card slot, it is important to
remove the card when transporting your notebook or Tablet
PC.
Note: During this time, the Sprint PCS Connection Manager
message area displays “Updating Hardware” and the Go
button is disabled.
Note: The card should fit snugly, but you should be able to insert or
remove it easily from your computer’s PC Card slot.