SIIG CYBER 2S1P - Manual (Page 9)

9
2. Click Settings tab and click Advanced.
3. Click the down arrow that is next to the COM Port
number box and select a COM port that is not in use.
Click OK.
4. Click OK, then close Device Manager to save the
changes. Follow steps 1-4 again to change the second
serial port if needed.
Changing Parallel Port Address (LPT)
Some parallel devices need a specific parallel port in
order to work. If your parallel device works properly, do
not change this setting.
Windows 95/98/98SE/ME
1. From the Device Manager window double click
Ports (COM & LPT), then double click CyberParallel
PCI.
2. Click Settings tab, check Enable use of I/O location
278h.
3. Click OK, click OK again to close Device Manager
and click Yes to restart Windows to save the changes.
Windows 2000/XP/Server 2003
1. From the Device Manager window double click
Ports (COM & LPT), then double click CyberParallel
PCI....
2. Click Port Settings tab.
3. At the LPT Port Number box, click the down arrow
and select an LPT port that is not in use.
4. Click OK, then close Device Manager to save the
changes.