Shure The SM58 Vocal Artist UHF - Manual (Page 8)

10
Shure UHF-R Wireless
Network Parameters
NOTE:
• The receiver reboots after you press ENTER to accept net-
work parameter changes
• In dual models (UR4D), these settings affect both receivers
(the dual receiver is treated as a single network device).
Set the Receiver Network Mode
Menu: Util > Network
1. Push the Control wheel to move the cursor to the Mode
parameter.
2. Turn the Control wheel to set the receiver to one of the
following values:
• DHCP: use this setting when connecting the receiver to a
DHCP server.
• Manual: allows you to set the receiver to a specific IP ad-
dress or subnet.
IP Address and Subnet
Menu: Util > Network
NOTE: To change these settings, the network mode must be
set to
Manual.
1. Push the Control wheel to move the cursor to any of the
following parameters:
• IP (IP address)
• Sub (Subnet mask)
2. Turn the Control wheel to change the value.
Device ID
Assists in identifying receivers through the Wireless Work-
bench Software (has no effect on network identification).
Menu: Util > Network
1. Push the Control wheel to move the cursor to the
DevID parameter.
2. Turn the Control wheel to set the receiver to change the
value.
Custom Groups
This feature allows you to create your own groups of
frequencies.
Creating new groups...
Menu: Radio > Custom
1. Turn the Control wheel to select a custom group number
( U1, U2, U3, etc.)
2. Push the Control wheel to move to the
Channel parameter and turn it to select a
channel (
01, 02, 03, etc.)
3. Push the Control wheel to move to the Freq parameter
and select a frequency for that channel.
4. Push the NEXT menu key to select a frequency for the
next channel in that group.