Sunbeam 1626 - Manual (Page 4)

7 6
S
TORAGE
1. Always store dryer inside the base.
2. Do not mount or store dryer in an area with excessive heat or moisture.
3. Do not wrap cord around dryer. Allow to hang loosely from dryer.
4. Do not hang dryer by cord or use cord as a handle.
5. Store in a cool, dry place and out of reach of children.
6. Store where dryer will not be accidentally damaged from bumping or falling.
Do not put anything on top of dryer.
M
AINTENANCE
, C
ARE AND
C
LEANING
1. Always unplug dryer from outlet before cleaning.
2. Clean dryer by wiping with a soft, lightly moistened cloth.
3. NEVER PUT HAIR DRYER IN WATER.
4. The motor never needs oil or grease.
5. Check the removable lint screen. It is important that you clean the removable lint
screen when hair, lint or dust begin to build up on it. To remove the screen,
rotate counter-clockwise and loosen. To clean, brush the outside of the screen
with a toothbrush to loosen lint, etc. Then turn the screen over and rinse under
a running faucet. Towel dry the screen thoroughly. If inside of screen is dirty,
brush gently with a toothbrush to clean. To replace screen, line up pegs on
inside of the screen with slots on side of unit and rotate clockwise to lock in place.
1. To remove lens:
Insert tool (screw driver, knife point, etc.)
in crevice to flex tabs.
2. Replace bulb and lamp holder as an
assembly by pulling straight out.
Each bulb can be replaced separately.
W ALL M OUNT
N IGHT
L IGHT
110V-120V
POWER
SUPPLY
3- FT . P OWER C ORD
R ELEASE
B UTTON
OFF
B UTTON
ON
B UTTON
R EMOVABLE
L INT S CREEN
H AIR D RYER
HIGH
MED
LOW
S WITCH
6- FT . P OWER C ORD
B RACKET
S CREW
N
IGHT
L
IGHT
F
EATURE
To change bulbs,
follow instructions below.
T
OP
H
OUSING OF
W ALL M OUNT
3- FT . P OWER C ORD
B RACKET
S CREW
L OCKING P LATE
STANDARD ON MODEL 001626-040-000
OPTIONAL ON MODEL 001626-020-000