How to put the detergent in, How to add the fabric softener, Water supply connector filter – Samsung SW55USP User Manual

Page 19

Advertising
background image

18_Installation & maintenance

Installation & maintenance

_19

HOW TO PUT THE DETERGENT IN

1. Open the detergent box by pulling in the direction of the arrow as shown in the

figure and then put the powder detergent in the detergent box.

2. Put in one-time amount of detergent evenly so the detergent may not brim

over the box.

HOW TO ADD THE FABRIC SOFTENER

Slide and open the cover in the direction of the arrow, insert the rinse detergent, and slide and close it in the
reverse direction.
When a proper amount (one time does) of fabric softener is stored in the softener

inlet, it is automatically put in at the last rinsing cycle.

Do not use detergent, bleach or starch into the Softener Inlet.
Using too much softener may produce unsatisfactory results.
Do not open the lid during the Spin Dry cycle. If added too early, its effectiveness

will decrease.

Do not leave the softener into the Softener Dispenser for a long time. Because

softner became stiff.

WATER SUPPLY CONNECTOR FILTER

1. Pull out the filter and wash well.

2. Pull in the filter and connect the hose to the inlet water

valve tightly.

3. Check if there is a leakage.

Note to tighten up the connector.

03
Installation & maintenance

SW55USPIW-02445K_EN(АУ½Г).indd 19

2009-05-28 ¿АИД 4:29:03

Advertising