Sony SNC-RZ30N/2 - Manual (Page 5)

"Day/Night" Function
The SNC-RZ30 offers a "Day/Night" function to
provide optimized sensitivity in both day and
night environments. As the scene darkens, the
infrared cut-filter is automatically replaced with
a clear filter and the camera switches to B/W
mode, requiring a much lower minimum
illumination level. Three modes can be set:
automatic, manual, or timer mode.
Image Transfer Using FTP/SMTP
Because the SNC-RZ30 supports both FTP and
SMTP protocols, JPEG still image data can be
transferred, as required, either to an FTP server or
to a specified e-mail address as a JPEG attachment.
Activity Detection/Alarm Trigger
The SNC-RZ30 has a built-in activity detection
function that can be set to trigger its two
output relays. When there is movement in the
field-of-view of the camera, the camera can
trigger either or both of its relays to, for
example, set off an audible alarm, turn on a
lamp, or send a signal to an electric door strike
to lock or unlock a door. In addition to using
the built-in activity detection function, the
SNC-RZ30 can be configured with up to three
external sensors for expanded functionality.
These sensors can also be set to trigger the
camera's output relays, or to move the camera
to a preset position.
Moreover, other actions can be performed at
the time of an alarm event triggered by either
the activity detection function or an external
sensor. For example, sending the image that
was captured when the alarm was activated, to
an e-mail address or to an FTP server is possible.
Also, because the SNC-RZ30 has 8 MB of RAM
designated as a buffer and a high-speed data-
transfer capability of up to 30 fps,
*6 hundreds of
images from before and after the alarm was
triggered can be buffered in the RAM and if
required transferred to an FTP server.
*6 The SNC-RZ30N transfers data at speeds up to 30 fps.
Two Type II PC Card Slots
Two Type II PC card slots are integrated into the
SNC-RZ30, and can accept the following types
of PC cards:
*7
Memory Card
You can increase the SNC-RZ30 storage
capacity by adding either a flash memory card
or an ATA Hard Disk Drive (HDD) card. IC
recording media such as a Memory Stick™
media card with a Memory Stick/PC card
adaptor can also be used.
Wireless Card
Wireless networks are becoming more prevalent
allowing you to install your SNC-RZ30 without
unsightly wires. The SNC-RZ30 is compatible
with IEEE 802.11b compliant wireless PC cards.
*7 Please contact your local Sony sales office for a list of
compatible PC cards for use with the SNC-RZ30.
Analog Composite Video Output
The SNC-RZ30 can output an analog composite
video signal via the BNC connector on the
unit's rear panel.
*8 This is an ideal feature for
sending signals to a local recording device or
monitor.
*8 The SNC-RZ30N output is in NTSC format (525/60).
PCMCIA Type II x 2
Rear Panel