Sony SAT-B65A - Manual (Page 14)

6
Getting started
3. Press SELECT again to test the first selection on the pop-up menu.
Your results will differ slightly from those shown, depending on your
geographic location and specific installation. However, if your results are very
different from these examples (i.e, rows of zeros or single-digit numbers):
• Highlight the
Antenna tab on the ANTENNA SETUP menu, then carefully
verify your settings for accuracy.
• Re-enter your ZIP code if necessary to verify you have used the correct
antenna pointing parameters for your location.
• Check your cable connections.
• Ensure the DIRECTV
® Receiver is connected to a modular telephone jack.
Once you have successfully obtained a signal and your test results resemble
those shown in the figures, call DIRECTV (or your subscription service
provider) to activate service if you have not done so already.
Antenna Setup pane
SYSTEM TEST
Prefs
Antenna
Signal
Return
Wed, Jun 13 10:15 PM
Test
New Card
Upgrade
Features
VCR
Xponder Test
System Tests
Begin Test
Exit
: 5317.6
:0.0.0.75
:OK
:OK
Xponder Test
Satellite 101 (A)
Satellite 119 (B)
Satellite 110 (C)
Cancel SYSTEM TEST
Prefs
Antenna
Signal
Wed, Jun 13 10:16 PM
Test
New Card
Upgrade
Features
VCR
Exit
System Tests
Begin Test
93
Satellite 101 (A) Signal Strength
94
93
92
94
94
93
94 95
92
92
94 95
94
93
93 94
94
93
95 95
93
93
95 95
94
95
94 95
94
93
94 1–8
9–16
17–24
25–32
Xponder Test
Test
Return
INSTALLATION
Prefs
Install
Signal
Return
Wed, Feb 13 12:16PM
Test
New Card
Upgrade
Features
Exit
VCR
Dish Type
Autoconfig
Dish Type:
Oval Dish 2
ZIP Code
Lat/Longitude
Dish Pointing Alignment Mode
ZIP Code :
Latitude :
Longitude :
Elevation :
Azimuth :
Tilt :
Networks:
0, 3
Switch Type:
Simple
LNB: Unstacked