SysKonnect SK-9Sxx - Manual (Page 15)

SysKonnect SK-9Exx/9Sxx Gigabit Ethernet Server Adapters
2 Connection of the Network Adapter
This chapter describes the physical connection of the network adapter to the network. General in-
structions for driver installation are given in chapter 3 “Installation of the Driver Software”.
Transmission Distances
Depending on the physical media (cable) different distances can be reached for transmission with
the Gigabit Ethernet adapter:
Connection to the Network
Observe the safety instructions given on page 11.
In order to connect the adapter to the data network, proceed as follows:
1. If necessary, configure the port on the switch to which the network adapter is to be connected
(also see the switch manual).
2. If possible, disconnect the switch and the computer from the power supply.
3. Remove the protective plug (if available) from the switch port, which is to be used.
4. At one end of the cable connect the LC duplex or RJ-45 connector to the port on the switch.
5. Remove the protective plug (if available) from the port on the network adapter (fiber-optic types
only).
6. At the other end of the cable connect the connector to the port on the network adapter (see
figure 2 “Connection of fiber-optics cables/plugs”).
The port type (e.g. 1000Base-T) on the network adapter and that on the switch must be identi-
cal.
Adapter Type Physical Media Maximum
Distance
1000Base-SX/LC
(850 nm) 1000Base-SX 50.0 µm multimode fiber-optic 550 m
1000Base-SX 62.5 µm multimode fiber-optic 275 m
1000Base-LX/LC
(1300 nm) 1000Base-LX 10.0 µm monomode fiber-optic 5000 m
1000Base-LX 50.0 µm multimode fiber-optic 550 m
1000Base-LX 62.5 µm multimode fiber-optic 550 m
10/100/1000Base-T Category 5 unshielded twisted pair 100 m