SysKonnect SK-9Sxx - Manual (Page 20)

20 3 Installation of the Driver Software
7. Type the path to the driver, e.g.
e:\SK-9Exx\Windows\WinME
, where “e” is the designation
of the CD-ROM drive on your system.
8. Click N EXT .
The window “Location of driver” is displayed.
9. Click N EXT to continue the installation.
The menu “Windows has finished installing the new hardware device” is displayed.
10. Click F INISH .
11. Restart your computer.
For more information, refer to the corresponding readme file.
Windows 2000
SysKonnect offers an NDIS 5.0 32-bit Miniport driver for the SysKonnect SK-9Exx/9Sxx Gigabit
Ethernet Server Adapter Family supporting Windows 2000.
To install the driver, proceed as follows:
1. After you have installed the adapter in your computer (for details, see chapter 1 “Installation of
the Network Adapter”), boot Windows 2000.
Windows 2000 detects the SysKonnect SK-9Exx/9Sxx Adapter as “Ethernet Controller” during
the boot operation.
The window “Found New Hardware Wizard” is displayed.
2. Click N EXT .
In the same window the menu “Install Hardware Device Drivers” is displayed.
3. Select the check box S EARCH FOR A SUITABLE DRIVER FOR MY DEVICE ( RECOMMENDED ).
4. Click N EXT .
The menu “Locate Driver Files” is displayed.
5. Select the source from which the driver is to be installed (e.g. CD-ROM, floppy disk, hard disk).
6. Type the path to the driver, e.g.
e:\SK-9Exx\Windows\Win2000
, where “e” is the designa-
tion of the CD-ROM drive on your system.
7. Click O K .
8. Click N EXT .
The menu “Driver Files Search Results” is displayed, listing the found driver and its location.
9. To install the driver, click N EXT .
In case the driver does not have a Microsoft Digital Signature yet, the window “Digital Signature
Not Found” is displayed.
10. To continue the installation, click YES .
The window “Completing the Found New Hardware Wizard” is displayed.
11. Click F INISH to complete the installation.
For more information, refer to the corresponding readme file.