Sunbeam 1620 - Manual (Page 3)

5 4
F
E AT U R ES O F
Y
O U R
H
A I R
D
RY E R
H
O S P I T A L I T Y
A IR O UTLET
C OOL S HOT
B UTTON
A IR I NTAKE
G RILL
O FF /L OW /M ED /H IGH
S WITCH
H ANGING R ING /
C ORD G UARD
O
P E R AT I N G
I
NST RU C T I O NS
This dryer is equipped with an appliance leakage circuit interrupter (ALCI) for your safety.
This device is designed to make the appliance inoperable under some abnormal conditions
(such as accidental immersion in water).
After the appliance is plugged in, you must check your protective device as follows:
1. Press the “Reset” button on the ALCI device.
2. Press the “Test” button. The “Reset” button will pop out. This verifies
that the protective device is working properly.
3. Press the “Reset” button once more to reactivate the safety device
and use your appliance.
REPEAT THE ABOVE PROCEDURE BEFORE EACH
USE TO CONFIRM THAT THE PROTECTIVE DEVICE IS OPERATING.
T
O
U
S E
Y
O U R
D
RY E R
With the control setting switch in the “O” position, plug the Dryer into a standard
110-125-volt AC outlet. Select speed (airflow) setting that is most appropriate
to your needs and that will deliver the best results.
The control setting switch marked “0”-“I”-“II”-“III,” controls the airflow speed of your
Hair Dryer. Press up on the switch until it clicks into position “I” for LOW speed,
“II” for MEDIUM speed or “III” for HIGH speed.
When finished using your Dryer, move the control switch to the “O” position
and unplug the cord from the outlet.
A
D D I T I O NA L
I
N FO R M AT I O N
COOL SHOT BUTTON (Refer to Diagram)
When drying hair use a higher heat setting and switch to a lower heat setting when drying
is nearly complete. To finish, press the Cool Shot Button. This will deactivate all heat flow
from the Dryer and blow cool air to lock in your hairstyle without causing over-drying or
damage to your hair.
CONCENTRATOR ATTACHMENT
Your Dryer comes equipped with an optional air concentrator attachment. Attach the
concentrator to the nozzle of your Dryer when you require extra airflow in certain areas.
Use to tighten a curl or wave or to loosen curly hair.
C
AU T I O N
Use your SUNBEAM ® Hospitality Hair Dryer with care. Directing a high volume of heat
continuously to one area can overheat hair and scalp. When using a HIGH heat setting,
hold the blower opening a few inches away from the hair, drying one section at a time.
Work layers of hair in quick strokes. Keep the dryer in motion until drying and styling
are complete.