Smeg Built-in Microwave Oven - Manual (Page 12)

14
Instructions for the user
7.7 Programmed cooking procedures
7.7.1 Semiautomatic cooking
Semiautomatic cooking is the function which allows a cooking operation to
be started and then ended after a specific length of time set by the user.
Select a function (see paragraph “7.6 Selecting a function”) and press PT1
twice. The display will show the
figures and the symbol
(flashing).
Turn PT1 to the right or left to set the minutes of cooking (from 00:01 to
23:59). A few seconds after the required duration is set, the
symbol will
stop flashing, and semiautomatic cooking will start from that moment. At
the end, the word STOP will appear on DSP1, cooking will stop and a
buzzer will sound; press PT1 to deactivate it.
If you wish to continue cooking beyond the set time, press PT1 again. The oven will
restart normal operation with the cooking settings selected previously. PT2 has to
be pressed to switch the oven off completely.
Modifying the data set
Once semiautomatic cooking has started, its duration can be changed.
When the
symbol is steady and cooking is in progress, press PT1
once. The symbol starts flashing and PT1 can be turned to change the
set duration. A few seconds after the last change, the symbol will stop
flashing, and semiautomatic cooking will restart from the new value.
To change the preset temperature, wait for the
symbol to become
steady and turn PT1 to the right or left to increase or decrease the cooking
temperature.
7.7.2 Automatic cooking
Automatic cooking is the function which allows a cooking operation to be started at
a set time and then ended after a specific length of time set by the user.
Select a cooking function, set the cooking temperature required or leave
the preset temperature (see paragraph “7.6 Selecting a function”) and
press PT1 twice. The display will show the
figures and the
symbol (flashing).
Turn PT1 to the right or left to set the minutes of cooking (from 00:01 to
23:59).
For safety reasons, when setting automatic cooking the user must first
program a cooking duration and then set the cooking start time. It is not
possible to set the cooking start time only, without setting the cooking
duration.