Sony J30SDI - Manual (Page 7)

Chapter 1
Overview
Chapter 1 Overview
1-1
Chapter
1
Overview
1-1 Before Using
When using this unit for the first time, set the number
of scan lines to the NTSC (525 scan lines, field
frequency 60 Hz) system setting or to the PAL (625
scan lines, field frequency 50 Hz) system setting
according to the operating environment in which the
unit will be used. Otherwise, it will be impossible to
use this unit.
To set this unit for the NTSC (525/60) or
PAL (625/50) system
1
Turn the POWER switch on.
When you turn on this unit for the first time,
indication, “SEL ------” appears in the time data
display area.
2
Holding down the JOG/SHUTTLE button, turn the
JOG/SHUTTLE dial to display “525” or “625”
next to “SEL”.
3
Press the SET/MENU button.
Indication “PUSH SET” appears in the time data
display area.
4
Turn the POWER switch off, and then on again.
The indication in the time data display area
changes as shown in the figure below.
You can see “POWER OFF/ON” by scrolling the
indication.
This unit is set for the 525/60 or 625/50 system and
indicator 525 or 625 lights above the time data display
area to show the selected system.
1,4
3 2
Time data display area