Snapper 1691356 User Manual

Page 12

Advertising
background image

1. Attaching:

a. Attach the cart to the tractor by aligning the two

ends of the H-frame to the holes in the bracket
(figure 26). Use the holes that will make the
level, Secure the cart to the bracket with
pins and hairpin

b. Attach the cart to the bracket at

3. Move the latch handle to the unlock position and

dump

cart’s box. The connecting tube will slide

off the elbow and the cart’s box will dump a 90

degree angle for quick unloading.

4. If bagging the grass clippings is desired, the grass can

be pulled from the cart at the curve side into a plastic
lawn bag. Also, the grass can be dumped onto a tarp

for throwing into a trailer.

Figure 26.

DUMPING GRASS AND LEAVES

1. Back the tractor to the desired place for unloading.

Shut the tractor’s engine off before getting off the

tractor’s seat.

2. Unhook the strap from the door lock and raise the

cover assembly to the open position. Lock the cover

in place by hooking the strap to the locking tab

(figure 27).

Figure 27.

A

WARNING

For

safety

and debris

to be

removed only after engine is shut off, key removed,
and

moving

stopped.

A

WARNING

Before

cover, shut off engine, remove key,

and set

brake.

A

CAUTION

Do not

haul sharp

that may

puncture the

cover.

5. The cover can be removed entirely from the cart.

Once the cover is removed, the

can be used for

hauling bulky loads.

A

CAUTION

Be sure to store the

in safe place where it

cannot he torn.

OPERATING WITHOUT COLLECTION SYSTEM

48” MOWERS

A

WARNING

When

blower assembly is removed from

deck, the deflector must be installed

described in

this section.

To operate without the grass collection system, remove
the blower assembly by removing the front wing nut (C,
figure 25) and slipping belt off of the pulley. Re-install the
mower deflector (figure 28) and the original hardware.
Install

carriage bolts from bottom and

washers and nuts (A). Install the front washers (B) and
nut (C). Be sure flat washers and

are used at

all three locations.

Pivot the

(A, figure 29)

the arbor pulley and

hook into position.

12

Advertising
This manual is related to the following products: