Spin Master Air Hogs Room Raider - Manual (Page 2)

CHARGING YOUR ROOM RAIDER TM
FLYING YOUR ROOM RAIDER TM
TM
Spin Master Ltd., 450 Front Street West, Toronto, ON M5V 1B6 Canada
Spin Master, Inc., PMB #10053, 300 International Drive, Suite 100,
Williamsville, NY 14221, USA
Spin Master Toys Far East Limited, Rm #1113, 11/F,
Chinachem Golden Plaza, 77 Mody Rd., Tsimshatsui E., Kowloon, HK
North American Consumer Information
Phone: 1-800-622-8339
www.spinmaster.com
TM and © 2006 Spin Master Ltd. Air Hogs ® is a registered
trademark of Spin Master Ltd. All rights reserved. Conforms to
product safety standards ASTM F963-03, EN71 regulatory
requirements. Products and colors may vary. Please retain this
information for future reference. Patent Pending.
MADE IN CHINA.
Item #44210 44210-ENG-IS-2
#20004655, #20004658 REV 2 US English
1. Open door on the controller to access
the charge cable.
2. Plug charge cable into the charge port.
3. Slide the power switch on the controller
to “CHARGE”. The charge light will flash
while charging and stop flashing when
the battery is fully charged.
4. Remove the charge cable from the
charge port, store it in the charger and
close the storage door.
NOTE: For best flight performance,
fully charge your Room Raider
TM before
each flight.
TROUBLESHOOTING
Room Raider TM
will not start or
has lost power.
Room Raider TM
is flying too low.
1. You have not set the motor switch to “ON”.
2. Battery power is low.
3. Batteries (+) or (-) are not correctly placed
inside the battery compartment.
4. Room Raider TM battery is low.
5. Safety auto-cutoff is activated.
1. Needs more power.
2. The batteries in the controller are drained.
3. Room Raider
TM battery is low.
1. Push motor switch to “ON”.
2. Replace the controller batteries.
3. Be sure to align the (+) and (-) polarities with the
corresponding markings inside the battery compartment.
4. Recharge Room Raider TM .
5. Turn jet off, wait 3 seconds then turn back on.
1. Squeeze the throttle trigger more.
2. Install new batteries.
3. Recharge Room Raider
TM .
PROBLEM SOLUTION CAUSE
1. Turn the jet “ON/OFF” switch to “ON”.
2. Turn the controller “ON”.
3. Hold the controller in one hand and jet
as shown.
4. Squeeze the throttle trigger about 1/2
way and gently toss the Room Raider TM
into the air. The Room Raider TM will begin
flying in circles to the left.
5. Control the altitude by squeezing the
throttle trigger.
Contains LiPo battery pack.
Battery pack must be
recycled or disposed of
properly.
Charge
Cable
Proper Grip for Launch
Do not
hold here
FCC REQUIREMENTS
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
1) This device may not cause harmful interference.
2) This device must accept any interference received, including interference that may cause undesired operation.
WARNING: Changes or modifications not expressly approved by the party responsible for its compliance could void the user’s
authority to operate the equipment.