Samsung DV665JS - Manual (Page 8)

A-2 SAMSUNG Clothes Dryers Owner’s Instructions
EXHAUST LENGTH CALCULATION
Table 1: RECOMMENDED MAXIMUM LENGTH
ELECTRIC DRYERS
Weather Hood Type
Recommended Use only for short run installations
↔ 4”(10.16cm) ↔ 2 1/2”(6.35cm)
No. of 90˚
elbows
Rigid Metallic Flexible* Rigid Metallic Flexible*
0 14m(46ft.) 9m(30ft.) 11m(37ft.) 7m(24ft.)
1 11m(38ft.) 7.5m(25ft.) 9m(30ft.) 6m(20ft.)
2 9m(31ft.) 6m(20ft.) 6.5m(22ft.) 4m(14ft.)
3 7m(24ft.) 5m(16ft.) 4.5m(15ft) 3m(10ft.)
* Do not use non metallic flexible duct.
EXHAUST DIRECTIONS
All dryers shipped from the factory are set up for rear exhausting. However exhausting can be on the
right or left side of the cabinet or the bottom of the dryer.
• Remove access panel at back of dryer to gain access to internal ducts.
• Disconnect duct exhaust from blower housing.
• Remove desired knockout plate (either right or left side).
• Attach a 90° elbow duct to blower housing and facing desired opening.
• Reinstall rear access panel.
EXHAUST DUCT LOCATING DIMENSIONS
NOTE: Non-metallic ducts must never be used inside dryer cabinet.
SPECIAL ACCESSORY
Stacking kit (Model no:SK-2A)
You can obtain the stacking kit from your retailer.
With this kit you can combine your dryer with a Samsung
automatic washing machine to a washing and drying column.
The appliances are stacked in a space-economizing manner in this
arrangement, the washing machine at the button and the dryer at the top!
Installation Instructions
Fr
on
t of dr
yer
Same as
other side
3-3/4”(9.5cm)
13-1/2”(34cm)
3-3/4”(9.5cm)
4-3/8”(11cm)
5-7/8”(15cm)