SimpleTech Zeus Ultra - Manual (Page 35)

Drive Configuration Installation
Zeus Ultra DMA Solid State Drives 29
3.2.2 Configuring 3.5-inch Form Factor Zeus SSD
Zeus SSDs conforming to the 3.5-inch form factor, use a 40-pin ATA bus/DC power
combination connector. To configure the SSD as either the Master or Slave device, place
a jumper across the appropriate pins (1 - 8) as illustrated in Figure 6 on page 29.
Figure 6. Master/Slave Setting for 3.5-inch Zeus SSDs
In systems with multiple drives, it may be necessary to configure disk
storage in a Master/Slave configuration. To accomplish this, boot the
computer using IDE HDD Auto Detection available in the CMOS setup.