SMC Networks SMC Tiger 10/100 SMC6128PL2 - Manual (Page 303)

Switch Clustering
3-251
3
IP pool when the switch is currently in Commander mode. Commander mode must first
be disabled. (Default: 10.254.254.1)
• Number of Members – The current number of Member switches in the cluster.
• Number of Candidates – The current number of Candidate switches discovered
in the network that are available to become Members.
Web – Click Cluster, Configuration.
Figure 3-157 Cluster Configuration
CLI – This example first enables clustering on the switch, sets the switch as the
cluster Commander, and then configures the cluster IP pool.
Cluster Member Configuration
Adds Candidate switches to the cluster as Members.
Command Attributes
• Member ID – Specify a Member ID number for the selected Candidate switch.
(Range: 1-36)
• MAC Address – Select a discoverd switch MAC address from the Candidate
Table, or enter a specific MAC address of a known switch.
Console(config)#cluster 4-329
Console(config)#cluster commander 4-329
Console(config)#cluster ip-pool 10.2.3.4 4-330
Console(config)#