Stoelting F144I - Manual (Page 23)

13
Figure 19. Auger Flight Wear and Front Auger
Support Bushing Wear
D. Place the FREEZING CYLINDER OFF-ON switch in
the OFF position.
To disassemble the freezer, refer to the following steps:
A. Remove the mix inlet regulator from the hopper by
pulling straight up.
B. Remove the front door by turning off the circular
knobs and then pulling the front door off the studs
(Fig. 20).
Figure 20. Removing Front Door
C. Remove the rosette caps from the front door. Push
the spigot body through the bottom of the front door
and remove. (Fig. 21).
Figure 21. Front Door Disassembly
D. Remove the front auger supports and bushings
(Fig. 23).
D. Remove the clear acrylic splash guard from the
blender.
E. Remove the blender's agitator from the agitator shaft.
Grasp the agitator shaft in one hand, and turn the
agitator in a clockwise direction with the other hand
(Fig. 22).
Figure 23. Removing Auger Supports
Figure 22. Removing Agitator From Shaft