Smeg FC32AP - Manual (Page 8)

64 64
GB
DESCRIPTION OF THE APPLIANCE,
BASIC PARTS
! THE APPLIANCE ACCESSORIES
LISTED BELOW MAY DIFFER FROM THE
ACCESSORIES OF THE APPLIANCE YOU
HAVE BOUGHT IN QUANTITY AND IN
DESIGN. THIS DESCRIPTION IS ADAPTED
FOR ENTIRE GROUP OF TWO–COMPARTMENT
REFRIGERATOR-FREEZER COMBINATIONS.
Fig. 1
A – refrigerator compartment
B – freezer compartment
1. Electricity (green light)
2. Thermostat
knob
3. On / off switch for interior light
4. Interior light block
5. Adjustable height shelves
6. Glass
shelf
7. Shelf for bottles
8. Fruit and vegetable boxes
9. Door
trays
10. Butter and cheese compartments
11. Bottle tray
12. Bottle holder
13. Egg tray
14. Thaw water channel cleaner (red colour)
15. Container for dumplings
16. Fast-freeze section
17. Frozen products section(s)
18. Ice-cube tray
19. Thaw water channel
20. Bottom cover
21. Supports
22. Casters
23. Levelling foot
24. Condenser
25. Compressor
26. Electricity supply cord
27. Thaw water drip tray
28. Rubber sealing gasket
PREPARING THE APPLIANCE FOR
OPERATION
! It is recommended to prepare the
appliance for operation with a helper.
• Remove
package.
• Lift the appliance away from foamed
polystyrene base.
• Tear off adhesive tapes.
• When positioning the appliance in chosen
location, it will move more easily into position if
you lift the front a little and incline it backward,
allowing it to roll on its casters 22 (fig. 1).
• Remove all red-coloured parts from the
shelves (fig. 2). Tear away the red-coloured
adhesive tapes from the door trays – they
are intended only for the transport of the
appliance.
NOTE. When you open the freezer compartment
door a little red packing detail will fall out – IT
IS FOR TRANSPORTATION PURPOSES ONLY.
• Suitably dispose the packaging material.
• Take two supports 21 from the bag (fig. 1,
3) and insert them into the guides at the top
back part of the appliance.
!
We recommend the model FC35AP to
fix additionally to the wall:
• Inserts the supports into the guides at the
top back part of the appliance (fig. 4).
•
Mark on the wall the position of the holes in
the supports.
• Drill holes in the wall and insert fixing
bushings. Secure the appliance to a wall.
POSITIONING
• Place the appliance in a dry, well ventilated
room.
•
The appliance should not be operated in an
unheated room or porch. Place the appliance
away from heat sources such as kitchen stove/
oven, radiators, or direct sunlight.
• The appliance must not touch any pipes
for heating, gas or water supply, or any other
electrical devices.
• Do not cover the ventilation holes at the
top of the appliances– it must be a good air
circulation around the appliance. There should
be a gap of at least 10 cm between the top