Sony WEGA KV-29FQ76 K - Manual (Page 55)

Getting Started 5
4
3
1. Connect your aerial lead to the aerial socket
labelled
on the rear of the TV.
Connecting an aerial only
1. Connect your aerial lead to the IN* socket on
your VCR.
2. Connect an RF lead from the OUT* socket on
your VCR to the aerial socket labelled
on
the rear of the TV.
3. Connect a fully wired 21-pin scart lead from the
scart socket marked
on the rear of the
TV to a scart socket on your VCR**
Notes: *Socket names may vary depending on
make and model of VCR. Refer to your VCR
instruction manual for details.
**If your VCR does not have a scart socket
follow the connecting instructions above
ignoring the scart lead connection.
You will also need to manually tune the VCR
to a spare TV channel (ideally channel 0,
refer to the ‘Manual Programme Preset
menu’ section of this instruction manual).
3/ s 3
Connecting an aerial and VCR
1. Connect the TV plug to your mains socket
(220 - 240V AC, 50 Hz).
2. The TV is usually switched on. If not, push in
the On/Off button (
) on the front of the TV.
If the red standby mode indicator on the front of
the TV is lit, press the TV
button on the
remote control to switch on the TV set. Please
be patient as the picture may take a few
moments to appear on the TV screen.
/
Connecting an aerial and VCR
Switching on the TV
On/Off button
Scart lead
(not supplied)
RF lead
(not supplied)
VCR
IN
OUT
29FQ76 B5 Part 2 GB.fm Page 5 Tuesday, May 7, 2002 11:53 AM