Sony MZ-NE410 - Manual (Page 31)

31
Explanations
About the DSP TYPE-S for ATRAC/ATRAC3
This recorder supports playback with the DSP TYPE-S specification for high-level Sony
MiniDisc decks equipped with digital signal processors (DSP). This specification allows tracks
recorded in MDLP mode to be played back with high quality sound. Since this recorder also
supports DSP TYPE-R specification, superb sound is produced during playback in SP (normal
stereo) mode as well.
Suppressing the skips of the sound (G-PROTECTION)
The G-PROTECTION function was developed to provide a higher level of shock resistance than that of
existing players.
The recorder does
not work or works
poorly. • The HOLD function is turned on (“HOLD” appears in the display
when you press an operation button on the recorder).
, Disable HOLD by sliding the HOLD switch to the opposite
direction of the arrow.
• The lid is not firmly closed.
, Close the lid until it clicks.
• Moisture has condensed inside the recorder.
, Take the MD out and leave the recorder in a warm place for
several hours until the moisture evaporates.
• The dry battery is weak (“LoBATT” flashes or nothing appears).
, Replace the dry battery with a new one.
• The dry battery have been inserted incorrectly.
, Insert the battery correctly.
• An MD with nothing recorded on is inserted (“BLANK” appears
in the display).
, Insert a recorded MD.
• The disc is damaged or does not contain proper recording (“Rd
ERR” appears in the display).
, Reinsert the disc. If the error message still appears, replace it
with another disc.
• While operating, the recorder received a mechanical shock, too
much static, abnormal power voltage caused by lightning, etc.
, Restart the operation as follows.
1 Remove the dry battery from the recorder.
2 Leave the recorder for about 30 seconds.
3 Insert the dry battery.