Sennheiser ASP 2 - Manual (Page 6)

18
Connecting the antennas
̈ You can connect the following antenna types to the
antenna inputs
ᕤ
and
ᕨ
:
! two A 1031-U or A 2003-U passive antennas or
! two A 12 active antennas or
! a combination of passive antenna (A 1031-U or
A 2003-U) and antenna booster (AB 2).
Connecting the receivers
You can connect up to four rack-mount receivers (e.g.
EM 100 G2, EM 300 G2 or EM 500 G2) to the ASP 2. The split-
ter incorporates DC distribution for powering the receivers.
̈ Pass the cables coming from the antenna spitter’s DC out-
puts
ᕣ
through the cable grips
µ
at the rear of the recei-
vers.
̈ Insert the hollow jack plugs into the sockets
¾
of the recei-
vers.
̈ Connect the BNC cables
ᕥ
and
ᕦ
of the antenna splitter to
the receivers as follows:
! Antenna outputs (OUT A) ᕦ
to antenna inputs (ANT I)
¹
! Antenna outputs (OUT B) ᕥ
to antenna inputs (ANT II)
¸
Note!
We recommend protecting unused RF outputs with a 50 Ω
terminator in order to keep to the specified distribution
attenuation.
ASP 2
¿ º
´ ²
ASP 2
»
ASP 2
µ ¾
EM 500 G2
¹ ¸
EM 500 G2