Sun Microsystems Sun Fire V20z User Manual
Sun fire, V20z server user guide
Advertising
Table of contents
Document Outline
- Cover page
- Proprietary Rights Notices
- Contents
- Preface
- Chapter 1 Introduction to the Sun Fire V20z Server
- Chapter 2 Powering On and Configuring the Server
- Chapter 3 Troubleshooting and Diagnostics
- Chapter 4 Maintaining the Server
- 4.1 Tools and Supplies Needed
- 4.2 Safety Guidelines (Before You Remove the Cover)
- 4.3 Locations of Components
- 4.4 Customer Replaceable Unit (CRU) Procedures
- 4.4.1 I/O Board
- 4.4.2 PCI Card
- 4.4.2.1 To Install a New PCI Card
- 4.4.2.2 To Remove an Existing PCI Card
- 4.4.3 SCSI Hard Disk Drive and Carrier
- 4.4.3.1 Replacing a Hard Disk Drive in a Carrier
- 4.4.4 SCSI Backplane
- 4.4.5 CD-ROM/DVD/Floppy Disk Drive Assembly
- 4.4.6 Operator Panel Board and Display
- 4.4.7 Power Supply
- 4.4.8 Cooling Fans
- 4.4.9 Memory Voltage Regulator Modules
- 4.4.10 CPU Voltage Regulator Modules
- 4.4.11 Memory Modules
- 4.4.12 System Battery
- 4.4.13 Cable Kit
- 4.4.14 CPUs
- 4.4.14.1 Removing a Heatsink and CPU
- 4.4.14.2 Installing a CPU and Heatsink
- 4.4.15 Super CRU
- Appendix A System Specifications
- Appendix B BIOS POST Codes
- Appendix C Diagnostics Commands