Sharp UX-B800SE - Manual (Page 40)

Caller ID (Requires Service)
38
Caller ID list on this page).)
If you do not need to have the area
code removed from local numbers
in the Caller ID list, press and
go to Step 7.
5 Enter the 3 digits of your area code.
6 Press .
7 Press to exit.
Note: Some caller ID services may not
provide the name of the caller. In this
case, only the phone number will
appear when you receive a call.
Display messages
One of the following messages will
appear while the machine rings if caller
information is not available.
NO
SERVICE No caller information was
received. Make sure that
your service has been
activated.
CALLER-ID
ERROR Noise on the telephone
line prevented reception of
caller information.
OUT OF
AREA The call was made from an
area which does not have
Caller ID service, or the
service is not compatible
with your service.
PRIVATE
CALL Caller information was not
provided at the caller’s
request.
STOP
Caller ID list
The machine keeps a log of the most
recent 30 calls and faxes you have
received (the Caller ID list). You can
view the list and automatically dial a
number from the list.
♦
The list is only available if you have
Caller ID service and have turned on
the Caller ID function.
♦
After you have received 30 calls, each
new call will delete the oldest call.
♦
The Caller ID list can also be printed.
See page 50.
1 Press until [< REVIEW
CALLS>] appears .
2 Press or to scroll
through the list .
•
To exit the list, press .
3 To dial a number, display the
number and:
•
Fax: Load the document and press
. Transmission will begin.
•
Voice call: Pick up the handset.
Dialing will begin automatically.
Deleting calls from the list
To delete a single call from the list,
display the call and press .
STOP