Samsung SSC14WEB - Manual (Page 101)

Eng-101
1. Click the “Router Status”
2. Click the WAN and LAN Port information.
Write down the WAN Port IP Subnet Mask number and the LAN Port IP Address number.
You will need it later when setting up the SSC14WEB.
3. Click “Advanced” and “Port Forwarding”
4. Port forwarding (HTTP)
! Click “Add Custom Service”
@ Service Name : Set this to “HTTP”
# Start Port and End Port : Set both to “From 10000 to 65535”
$ Server IP Address : SETUP MENU -> 7. NETWORK SETUP -> Check IP from
network status to apply it identically to Private IP after DHCP
setup. (Eng-32 Setup)
* It is not in use by any other device connected to the IP Router including the Local PC.
% Make sure “Enable” is checked.
^ Click “Add”
5. Close browser window.
Step-by-Step Setup Example of IP Router
Netgear model WGR614v4