Stinger CT100 - Manual (Page 8)

OPERATIONAL INSTRUCTIONS cont’d.
b. Open Lure Chamber by pulling door down at the bottom
of exhaust ring (Figure 11B).
c. Fit the lure cartridge into the Chamber and push the
lure door closed until it locks in place. Purchased
additional lures can be stored in the Extra Lure Storage
Drawer for convenience (Figure 12).
d. To remove, simply discard bait appropriately in a trash
receptacle. Note: although there may residue left in
the cartridge, active ingredients will be exhausted.
7. Set Lure Timer. Setting the REPLACE LURE Timer will tell
you when to replace the chemical bait to the trap. Always
set the timer when you install a new lure. The REPLACE
LURE indicator light will blink YELLOW when the lure needs
to be replaced.
a. For a 60 day lure, press the REPLACE LURE (
)
button and hold 3 seconds until YELLOW indicator light
blinks twice (indicates a 60 day timer) (Figure 13).
b. For a 30 day lure, press the REPLACE LURE ( ) button
and hold 1 second and Press POWER ( ) button until
YELLOW indicator light blinks one time (indicates a 30
day timer) (Figure 14).
8. Ensure Bug Basket is installed properly. See above
INSTALL BUG BASKET.
SmartTemp Mode: The Stinger ® Mosquito
Vacuum is designed to function only when
mosquito populations are present. Mosquitoes are
present when temperatures are in the range of
50-95°F. If the temperature, night or day, is out of
this range, the unit enters a SmartTemp Mode
where the burner shuts down to conserve gas and
the fan continues to run to keep captured
mosquitoes within the Bug Basket. During this
mode, the POWER ( ) light indicator blinks
GREEN. The Mosquito Vacuum will automatically
turn itself back on when the temperature falls
back in the optimal mosquito range.
Figure 11B
Figure 12
Figure 13
Figure 14
8
CT100_OM.qx 2/9/07 2:19 PM Page 8