Sennheiser SK 500 G3 - Manual (Page 26)

25
Adjusting settings via the operating menu
̈
Set the desired frequency bank.
̈
Set the desired channel.
̈
Set the desired frequency.
Setting the mode for the MUTE switch – “Mute Mode”
For information on how to use the MUTE switch, refer to
page 14.
Adjusting the transmission power – “RF Power”
Via the “ RF Power ” menu item, you can adjust the transmis-
sion power in two steps.
̈
Press the SET button.
The frequency selection appears.
̈
Press the SET button.
The frequency selection appears.
̈ Press the SET button.
Your settings are stored.
You are back to the operating menu.
Mode Function
“ AF On/Off ” When the switch is in the MUTE posi-
tion, no audio signal is transmitted.
“ RF On/Off ” When the switch is in the MUTE posi-
tion, the RF signal is deactivated.
“ Disabled ” The muting function is deactivated.
It is vital to observe the notes on the supplied
frequency information sheet.
Set the frequency
bank and the channel Set the frequency;
store the setting Call up “Tune”
(special function)
Advanced Menu
Tune
“Stored”
542.625 MHz
SET SET
SET
542.625 MHz
Tune
B.Ch: U1 . 1
542 .625 MHz
B.Ch: U1. 1
Tune
Call up “Mute
Mode” Select the desired
setting Store the setting
Advanced Menu
Mute Mode
Mute Mode Mute Mode
RF On/Off AF On/Off
AF On/Off
“Stored”
SET
SET
Call up
“RF Power” Select the desired
setting Store the setting
Advanced Menu
RF Power Standard
Standard
RF Power
Low
RF Power
“Stored”
SET
SET