Smeg DW1410 - Manual (Page 28)

User instructions
57
6. Troubleshooting
The dishwasher is capable of signalling a number of faults through the
simultaneous illumination of several indicator lights, with the following
meanings:
FAULT DESCRIPTION
E1
The dishwasher’s anti-flooding system has been
activated (only for models equipped with the
"TOTAL ACQUASTOP” device).
This alarm is triggered in the event of a water leak in
the dishwasher. In such circumstances the technical
service centre must be called.
E3
The dishwasher fails to heat the water.
Repeat the wash program. If the problem persists,
contact the customer technical service centre.
E4
The temperature monitoring system has failed.
Switch the dishwasher off, switch it back on and
restart the washing program.
If the alarm recurs, call the After Sales Service.
E5
The dishwasher fails to draw water.
Ensure the plumbing connections are in order and
that the water supply tap is open.
E6
The dishwasher fails to drain.
Check that the drain hose is not kinked, the siphon
is not obstructed and the filters are not clogged.
Light off Light on Light flashing
If an alarm occurs the appliance interrupts the program in progress and
signals a fault.
• In case of E1, E3 and E4, the washing program must be set again to
continue.
• In case of E5 and E6, simply open and close the door to continue (once
the cause of the fault has been illuminated).