Sharper Image SI868 - Manual (Page 6)

Temperature Control
Use the remote control to set a desirable temperature point for the
fan. Although there is a temperature readout on the remote itself,
the measurement that controls the fan is taken at the fan. This
way, if the remote is left in direct sunlight, next to a window and
getting a false reading, it will not affect the operation of the fan.
The fan stops and starts automatically according to the room
temperature as measured at the fan.
To activate the fan and display, press
POWER.
To activate automatic monitoring,
press AUTO.
To display the set temperature and
raise or lower it, press the TEMP +
or – button.
Once the set temperature is reached,
the fan will switch off.
To cancel and resume full-time
operation, press AUTO.
TEMP Settings
Unplug the unit before cleaning and allow it to dry before
returning the plug to the power outlet.
The exterior of the unit and the remote control can be cleaned
using a soft cloth or sponge, and a mild solution of dishwashing
detergent.
The front and rear grills can be
taken off the main housing for
easy removal of any dust col-
lected on the grills or interior
of the fan.
Press the two release buttons
on the side of the rear grill to
unlock it from the housing.
A release latch for the front grill
is hidden at the bottom. Pull the
latch forward to unlock the grill.
Use a vacuum to remove visible
dust from the grills and interior.
Rear Grill Release
Front Grill
Release Latch
Hidden below
grill edge.
Cleaning Instructions
SI868_ IM_120x120.indd 10-11 3/31/05 10:55:34 AM