Sharp XG-C430X - Manual (Page 50)

-48
Using the “Options1” Menu
Menu operation Page 42
4 4 4 4 4 Keystone Correction
When the image is projected either from the top or from
the bottom towards the screen at an angle, the image be-
comes distorted trapezoidally. The function for correct-
ing trapezoidal distortion is called Keystone Correction.
Auto Keystone Correction
Set “Auto Keystone” on the “Options1” screen menu
to “On”.
Manual Keystone Correction
Set “Auto Keystone” on the “Options1” screen menu to
“Off”, and select “Keystone”, then adjust with the slide bar.
Manual Correction
Note
• The Keystone Correction can be adjusted up to an
angle of approximately ±12 degrees with the “Auto
Keystone” and up to an angle of approximately ±40
degrees with the manual “Keystone”.
(when “Resize” is set to “Normal”)
• When the screen is slanting or the image is deterio-
rated, set “Auto Keystone” to “Off”.
• When adjusting the keystone or when “Auto Keystone”
is set to “On”, “Image Shift” is auto matically set to “0”.
Note
• When “Eco/Quiet Mode” is set to “On”, the power
consumption will decrease and the lamp life will
extend. (Projection brightness decreases 20%.)
• You can also use ECO/QUIET button on the re-
mote control or on the projector to switch the Eco/
Quiet Mode. (See page
36 .)
Selectable items
Logo
Blue
None
Description
SHARP default image
Blue screen
Black screen
Description
All On-screen Displays are displayed.
• INPUT mode/VOLUME/AV MUTE/
FREEZE/AUTO SYNC/ENLARGE/
“An invalid button has been pressed.”
are not displayed.
• “All buttons on Projector are locked.”
is displayed when STANDBY/ON is
pressed while the Keylock function is
active.
Selectable items
On
Off
5 5 5 5 5 Setting On-screen Display
This function allows you to turn the on-screen
messages on or off.
6 6 6 6 6 Selecting a Startup and
Background Image
7 7 7 7 7 Eco/Quiet Mode Setting
| | | | | button \ \ \ \ \ button
Description
The projector automatically enters the
standby mode when no input signal is
detected for 15 minutes or longer.
The Auto Power Off function will be
disabled.
Selectable items
On
Off
8 8 8 8 8 Auto Power Off Function
Note
• When the Auto Power Off function is set to “On”,
5 minutes before the projector enters the
standby mode, the message “Enter STANDBY
mode in X min.” will appear on the screen to
indicate the remaining minutes.
Bright-
ness
80%
100%
Select-
able
items
On
Off
Fan
Sound
Low
Normal
Lamp life
Approx.
3,000
hours
Approx.
2,000
hours
Power
consumption
(When using
AC 110V)
300 W
360 W