SMC Networks SpacePC 1232 Series - Manual (Page 33)

33
33
ATX Power Supply
¾ Connect pin 1 and pin 7 to the ground signal of the ATX Power Supply Unit.
¾ Connect pin 2 and pin 8 to the +5VDC source on the ATX Power Supply Unit.
¾ Connect pin 4 to the +12VDC and pin 6 to the –12VDC sources on the ATX Power Supply
Unit only if requested by other boards connected to the PC/104 ISA bus (see the following
note).
¾ Connect pin 11 to the +5VSB source on the ATX Power Supply Unit. This signal is always
high, even if the power supply is turned off.
¾ Connect pin 12 to the ATX ON signal of the ATX Power Supply Unit. This signal is used to
power on the Power Supply itself.
Power button
If the soft power management is enabled, a low signal in this pin turns the system on or off.
Note. The +12VDC and -12VDC voltages are neither used nor generated by the
SpacePC 1232 module: they are only conveyed on the PC/104 bus (connector J1)
and can be used by other devices or modules that are stacked onto the CPU module.
WARNING! IMPROPER CONNECTION OF THE POWER SUPPLY WILL RESULT IN
SERIOUS DAMAGE FOR THE MODULE.
J13 Fan power supply connector
It is possible to connect a fan to this connector (3pin, 2.54-mm step) according to these electrical
requirements: 5V, 500mA max.
J13
- +
Figure 19. J13 Connector layout
The connector pin out is shown below.